Hey everyone, I wanted to share my recent experience with the Aeotec Multisensor 7 after encountering some issues. I installed two of these sensors in my system, and they worked flawlessly for a while. However, after restoring my instance due to a critical error, I noticed that the sensors were freezing and not providing updates. This threw off a dozen automations I had set up, which was quite frustrating! Initially, I tried reinterviewing the sensors, and it worked for a few minutes, but then they stopped updating again. I also attempted to rebuild the routes, but it didn’t seem to help. After some research and troubleshooting, I found that deleting the devices and then repairing them was the solution that worked for me. It was a bit of a hassle, but it brought everything back to normal! For anyone else experiencing similar issues, here are a few tips: - Always ensure your firmware is up to date before making any changes. - If you’re restoring your instance, double-check that all devices are properly reconnected. - Don’t hesitate to reach out to the community for advice – we’re all here to help! I’m really glad I was able to resolve this issue and get my sensors back up and running. It’s a testament to how resilient and reliable these devices can be, even when things go sideways. Happy automating everyone! 