Hello community,
I’ve recently integrated the Aqara H1 (WRS-R02) Zigbee switch into my setup using Zigbee2mqtt. This double rocker switch is supposed to support a variety of functions, including single, double, and triple presses on both left and right sides, as well as simultaneous presses. According to the specifications, there are 12 different functions available. However, I’ve noticed that only 5 of these functions are showing up as triggers when I try to use them in automations. The others simply aren’t present.
To troubleshoot, I tried removing and relearning the device, but this didn’t help. In fact, after relearning, none of the triggers were available at all. I’m hoping someone in the community might have encountered this issue before or could offer some insight into what might be going wrong. Any tips or suggestions would be greatly appreciated!
Thanks in advance for your help!
Best regards,
Markus