Hey everyone, I’m currently trying to bridge two Vera devices, but I’m running into a bit of a snag. The issue is that I can’t seem to check the box for ‘Scan for UPnP devices’ under the UPnP section in ‘Add Devices.’ It feels like it’s locked out or something. This is happening on both my Vera 3 and Vera Lite, and it’s persistent even after I upgraded to the beta firmware to support the Aeotec Multi-sensor. I was really hoping to get this all set up today, but it’s proving to be a bit of a challenge. I wonder if anyone else has encountered this or knows a workaround. I’ve tried everything I can think of, but I’m still stuck. Any insights or suggestions would be greatly appreciated! Looking forward to hearing from you all. Cheers, Mark