Hi everyone, I’m working on a project with my Z-Wave radiator thermostats and I’m trying to figure out how to create a virtual item to control the setpoint. I’ve been using HabPanel to control them, and it works fine, but I want to have more control over the settings. I’ve set up a knob where I can adjust the setpoint, but I’m not sure how to bind it to a virtual item so I can write the setpoint to this item and then use it in a rule. Does anyone have a good idea on how to do this? I think creating a virtual item might be the way to go, but I’m not entirely sure. Any advice would be greatly appreciated! 