I recently installed the Eufy Security Smart Lock Touch & Wi-Fi in my home, and I must say, it’s been a fantastic addition! The fingerprint sensor and touch keypad are sleek and user-friendly. Plus, the built-in Wi-Fi allows me to lock and unlock it from anywhere, which is super convenient. However, I noticed that the fingerprint reader isn’t 100% accurate yet. If I get a red light, I just slide my finger down to the keypad, and it works perfectly. I have five access codes set up, and it’s reassuring to know there’s a backup key and phone app if I forget them. Installation was straightforward, and the included parts made it a breeze compared to my old Schlage lock. The only downside is the lack of Hubitat integration, which would be great for monitoring battery levels and lock status on my dashboard. I’m hoping someone in the community can create a driver for this lock soon!
On another note, I recently installed a Shelly 4 PM Pro with an RC Snubber for my wet-use circuits. It’s been working well, but I encountered an ‘OVERCURRENT’ message when connecting a vacuum cleaner. I followed the installation instructions correctly, but the issue persists. I’m curious if anyone else has faced this problem and how they resolved it. Any advice would be greatly appreciated!