Hi everyone, I’m excited to share my recent experience setting up automation between my Wyze camera and Wyze light bulbs. After some trial and error, I managed to create a system that turns the lights on when motion is detected and off after a few minutes of inactivity. While the initial setup was straightforward, turning the lights off proved a bit tricky. I tried using a rule to turn the lights off after a delay, but it didn’t work as expected. After some research, I discovered that adjusting the automation settings and using a combination of timers and motion sensors was the key to making it work seamlessly. I’d love to hear if anyone has tips or alternative approaches for this kind of setup! 