I recently purchased a HomematicIP 8-key remote control, and I must say, it’s been a fantastic addition to my smart home setup! After integrating it with my CCU2, I was eager to customize its functionality. One feature I wanted to implement was the ability to toggle switches with a single press—on with the first press and off with the next. While I stumbled a bit at first, I eventually figured it out through some trial and error. Here’s a quick tip for anyone looking to do the same: make sure the remote is properly paired and check the device settings in the CCU2 interface for any toggle options. It’s all about finding the right balance between simplicity and functionality. Now, my remote not only looks sleek but also operates seamlessly, making my daily routine a breeze. Happy smart home tinkering everyone! 