Hey everyone, I’ve been diving into integrating some new Aqara locks into my smart home setup and wanted to share my experiences and ask a few questions. I’ve been using a Sonoff Zigbee stick, but I’m not entirely sure if it fully supports Matter protocol for these locks. Has anyone successfully integrated Aqara locks with Matter? Any tips or workarounds would be greatly appreciated!I’ve also been dealing with some camera issues, specifically with the Amcrest IP2M-841. It shows as active on my hub, but when I try to view the camera, it just says ‘Camera not available.’ It’s wired and in the same room as my hub, so I’m a bit puzzled. I’ve followed the setup instructions to the letter, but no luck so far. Any troubleshooting steps or insights would be super helpful.On a lighter note, I recently updated the firmware on my Multi-IO module and encountered a failure. The update process seemed to go smoothly at first, but then it threw an error. I’ve tried it a few times with the same result. I’m wondering if there’s a specific time of day or method that’s more reliable for firmware updates. Maybe I’m missing something simple.Lastly, I wanted to share a quick comparison between Aqara and Xiaomi door/window sensors. I’ve been using both for a while now, and while they’re almost identical in functionality, the Aqara sensors have a slight edge with their button design for pairing. It’s a minor detail, but it makes setup a bit smoother. I’d love to hear if others have noticed similar differences or have preferences between the two.Thanks for reading, and I hope this thread sparks some helpful discussions. Let’s keep the community knowledge flowing! 