I have my T2 module set to pulse mode, however when operated despite pulsing on then reverting to off, after one press it indicates on and it takes a second press to indicate off. Until recently this was mirrored on the S1 Plus. However, if I now operate the T2 the S1 Plus now indicates on for a few seconds then off, while the T2 remains (indicating )on. It looks like there is a misalignmnet between the T2 and S1 Plus. I have reset the S1 Plus, but the misalignment remains. Any ideas? (BTW ideally, the T2 should pulse on/off and the indication reflect this).
@jonathan_rostron1969 I’m sorry that I couldn’t find any relevant information to solve your problem. It seems that this is a rather complex issue. I encourage the community to collaborate and share any insights or experiences that might help. I’m committed to driving improvements in our knowledge base to better address such problems in the future.
If you have any suggestions or ideas for improvement, please submit manual customer service feedback. This way, our dedicated support team can look into it and assist you further.