Hello everyone, I’m reaching out to the community for some guidance regarding the Aeotec Nano Shutter. I recently acquired this device and successfully paired it with my system, but I’m encountering an issue where there’s no driver available to control it. This is quite puzzling, as I expected it to integrate seamlessly with my existing setup.
I’ve done some research and found that the device has specific clusters and identifiers, but I’m not entirely sure how to proceed from here. The device uses Z-Wave Secure Pairing, and I’ve ensured that the necessary clusters are properly configured. However, without a driver, I’m unable to utilize its full functionality.
I’m curious if anyone else has encountered this issue or if there’s a workaround I can implement while waiting for an official driver. Perhaps there’s a way to manually configure the device or use a generic driver as a temporary solution. Any insights or suggestions would be greatly appreciated!
Thank you in advance for your help. I’m eager to get this device up and running to enhance my smart home setup.