I recently purchased the Shelly Pro 3EM and an additional 120A Neutral Clamp to enhance my energy monitoring setup. After correctly installing the clamp on the Neutral wire and following the calibration guide, I noticed something odd—the interface didn’t display any measurements or information related to the Neutral wire. I was a bit puzzled since the calibration seemed successful, with a confirmation message and a small star indicating user calibration in the diagram view. However, the absence of any Neutral wire data was frustrating. I reached out to the community for insights, and while some suggested potential fixes, I’m still waiting for a clear solution. Has anyone else encountered this issue or found a workaround? I’d greatly appreciate any advice or experiences shared by the community!