Hi everyone! I’m diving into the world of smart lighting and wanted to share my experience and some questions I have. I recently set up RGBW LED Strip lights in my living room, and it’s been a fun project so far. I’ve got a 22’ run of lights, and I’m trying to figure out the best way to power and control them without any issues.
I reached out to Fibaro tech support, and they mentioned using multiple RGBW controllers in a Master/Slave setup instead of an amplifier. They explained that using an amplifier could cause color issues, so using additional RGBW modules seems like a better solution. However, I’m not entirely sure how to implement this, especially since I’m using a Vera Plus controller. Has anyone successfully used multiple Fibaro RGBW modules in a Master/Slave configuration with Vera Plus? Any tips or experiences would be super helpful!
I’m also curious about others’ experiences with similar setups. How do you handle power consumption and ensure consistent color output across longer runs? Any troubleshooting tips or best practices would be greatly appreciated. Let’s keep the discussion positive and informative—looking forward to hearing from you all!