Hi everyone, I wanted to share my recent experience with integrating the LeakSmart Zigbee Moisture Sensors into my Hubitat setup. I’ve been following the community efforts for these sensors and was really excited to see the official release of firmware 2.2.4. After configuring both old and new version sensors, I must say the pairing process was seamless and the sensors themselves work perfectly in detecting leaks and providing timely alerts. However, I encountered a minor hiccup where the sensors wouldn’t change their state from dry to wet within Hubitat, despite functioning flawlessly otherwise. After some research and reaching out to the community, I found that adjusting the sensor sensitivity settings in the Hubitat app made all the difference. Now, the sensors reliably update their states, and I’m thrilled with how this has enhanced my home’s security. It’s amazing how a little tweak can make such a big difference! I’d love to hear about others’ experiences with these sensors and any tips they might have for optimizing their performance. Happy automating! 