Hello everyone, I recently got my hands on the Wyze Watch 44 and wanted to share my experience with the firmware update process. Initially, I encountered some issues where the watch would only stay on for a few seconds or minutes before turning off. It was quite frustrating, especially since I had to wait over an hour to try again. However, after some research and troubleshooting, I managed to resolve the issue. Here’s what I did:
- Firmware Update: I made sure the watch was fully charged before starting the update. This seemed to help with the stability after the update.
- Rebooting: After the firmware update, I gave the watch a full reboot. Sometimes, a simple restart can work wonders.
- Battery Check: I also checked the battery health in the settings to ensure it wasn’t degraded, which could cause unexpected shutdowns.
Now, the watch works like a charm! It’s been running smoothly without any interruptions. I’d like to hear from others who might have faced similar issues and how they resolved them. Sharing tips and experiences is always helpful for the community. 
If anyone is struggling with their Wyze devices, feel free to reach out, and I’d be happy to help if I can! Happy tinkering! 