Hey everyone, I’m reaching out with a couple of questions I’ve been struggling with lately. First off, I recently purchased a C-8 Pro Z-Wave controller and I’m trying to add my first Z-Wave device, a Beasen Smart Roller Blind. I followed the SmartStart process, scanned the QR code, and everything seemed to be going smoothly. However, the device status is stuck at ‘not included, pending’ and it’s been over two hours now. I’ve tried excluding and including the device again, but nothing seems to work. Does anyone have any suggestions on how to resolve this? I’m a bit stuck and would appreciate any advice!
Moving on to my second issue, I have a sensor set up to calculate the self-consumption of my PV system. It works by subtracting the produced PV power, battery charging power, and grid feed-in. The problem is that this sensor resets every day, which messes up my long-term calculations. I’ve tried using a Verbrauchszähler, but it doesn’t seem to be handling the data correctly. Is there a way to prevent this sensor from resetting daily? I’m really hoping there’s a solution out there!
I’d be incredibly grateful for any insights or workarounds for these issues. Let’s see if we can crack this together! 