Hello everyone! I’m currently working on integrating my heating system with a CCU2, and I’m facing a bit of a challenge. I have two radiator thermostats (HM-CC-RT-DN) and a wall thermostat (HM-TC-IT-WM-W-EU). Previously, I had all three devices coupled together, and I could regulate the radiators using the wall thermostat. Now that I’ve switched to a CCU2, I had to decouple them to connect the wall thermostat to the CCU2. The connection was successful, and I can see all the devices in the interface. However, I’m struggling to figure out how to configure the CCU2 so that the wall thermostat can control the radiators again. The wall thermostat appears with various labels, and I’m not sure which ones to connect directly. Any guidance or tips would be greatly appreciated! Thanks in advance and have a great week ahead!