Hello everyone, I’m thrilled to share my recent experiences with integrating ESPHome into my HassIO setup and addressing some battery-related challenges. As a passionate DIYer, I’ve been working on enhancing my smart home ecosystem, and I thought it would be beneficial to document my journey and solutions for anyone facing similar issues. ESPHome Integration in HassIO I recently decided to reinstall HassIO on my system, and I wanted to incorporate ESPHome to leverage its powerful features for my ESP32 devices. The installation process seemed straightforward—adding ESPHome from the HassIO repository and confirming its installation via the system logs. However, I encountered an unexpected issue where ESPHome wouldn’t appear in the dashboard. This was a bit puzzling, as there were no error messages indicating a problem. After some research and troubleshooting, I realized that the integration might not be automatically visible. I decided to explore the add-ons section more thoroughly and discovered that ESPHome was indeed installed but required manual activation. By navigating to the add-ons page and starting the ESPHome service, it finally became accessible. This was a minor hiccup, but it taught me the importance of thoroughly checking the add-ons section. Battery Drain on Fibaro Contact Sensor Another challenge I faced was with a Fibaro contact sensor I recently added to my setup. Despite configuring it to report temperature every 6 hours and monitor open/close status, the battery drained completely within just 3 days. This was concerning, especially since I had set up a rule to notify me when the battery reached 25%, which never triggered. To diagnose the issue, I reviewed my configuration settings and realized that the sensor’s reporting interval might be too frequent. I adjusted the settings to increase the reporting interval and also ensured that the sensor wasn’t inadvertently being triggered by external factors. Additionally, I checked for any firmware updates for the sensor, which resolved the issue of the low battery notification not being sent. Community Support I must express my gratitude to the vibrant and supportive community here. Whenever I encountered a roadblock, whether it was related to ESPHome integration or battery management, I found valuable insights and solutions through discussions and shared experiences. It’s truly inspiring to be part of such a collaborative environment. Conclusion My recent projects have been both challenging and rewarding, providing me with a deeper understanding of my smart home setup. I hope that by sharing my experiences, I can help others navigate similar issues and make the most of their smart home devices. If anyone has questions or suggestions, I’d be happy to discuss further! Happy tinkering! 