I’ll install it right away and then see if I can connect the P100 multi-state sensor via Zigbee. Fingers crossed 
Update:
Unfortunately, this isn’t the update I was hoping for.
The sensor still isn’t working via Zigbee. 
Yeah, sadly. I read somewhere about a version 4.5.20_0020.0017 which finally would bring the functionality with it. But I cannot verify that, because I’m not using beta firmware releases.
But thanks for testing!
Thanks for letting me know. I’ll set that up right away. In the meantime, I’ve connected the P100 via Zigbee2MQTT.
Yeah, I also hope the P100 will now connect to the G5 Hub finally.
I would briefly cut the power supply, and then—instead of trying to update them all at once—update the cameras one by one.
Do it not here 
, but here 
.
