Hi everyone, I’m new to the Raspberry Pi and Home Assistant community, and I’m encountering some issues with the AIO installer on my Raspberry Pi 3. I’ve installed Raspbian Jessie and performed a clean install, but every time I run the AIO code with the -n flag, it fails after about five or six attempts. The installation process gets to a certain point and then the Pi restarts. I’ve shared the terminal output in a gist, but I’m not sure how to interpret it. If anyone with more experience could take a look, I’d greatly appreciate it. Link to gist
The terminal output shows several lines of code being built, such as Building hid.o, Building aeskey.o, and others, but it gets truncated. I’m not sure if these are errors or just part of the installation process. I’ve tried running the installer multiple times, but the issue persists. I’m wondering if there’s a specific step I’m missing or if there’s a known issue with the AIO installer on Raspberry Pi 3.
I’ve also heard that sometimes the Raspberry Pi can have hardware issues, but I’m not sure if that’s the case here. I’m looking for any advice or troubleshooting steps that could help me resolve this issue. Maybe there’s a configuration setting or a compatibility issue I need to address. Any guidance would be really helpful!
Thanks in advance for your time and assistance!