Hi everyone, I wanted to share my experience with setting up the RFXcom device on my Raspberry Pi running OpenHAB. Initially, I was facing a frustrating issue where the RFXcom transceiver wasn’t connecting properly, resulting in error messages. The frustration was real, especially since I had followed all the setup instructions carefully. However, after some thorough troubleshooting, I discovered that the problem was due to incorrect binding settings in OpenHAB. It turns out that OpenHAB had created two bindings for my RFXcom device, and one of them wasn’t working. By identifying and correcting the binding address, I was able to resolve the issue and get my RFXcom up and running smoothly. This experience taught me the importance of checking all bindings and configurations when setting up new devices. I hope this helps anyone else who might be encountering similar issues. Happy automating! 