Hello community, what do you want to achieve with the new sensor? What automations do you want to do with it? Where do you use this?
I will use it in the living room, bathroom, toilet, and hallway.
I’ll put it where it’s far from my sockets.
1 Like
I will replace the P1 sensor and the FP2 presence sensor with the new FP3 sensor in all rooms.
2 Likes
Bathrooms seem like the ideal spot for this sensor. Unlike standard PIR sensors, it can detect movement even through a shower curtain, which is great for keeping the lights on while showering at night. Plus, since most bathrooms only have one outlet, using this sensor would free it up and eliminate the hassle and safety risk of extra wires. Definitely excited about the possibilities.
4 Likes
For now to handle the lights automatically when I enter/leave a room.
So far set up the toilet, storage room, kitchen and office.
When I enter the toilet, light pops on turns off once my presence isn’t detected anymore.
Handy when you’re in a rush.
When I go into the storage, light pops on and turns off when my presence isn’t detected anymore.
Handy when your hand are full.
In my office, lights and monitor turn on. When my presence isn’t detected anymore it turns of the monitor, printer and lights. The delay I have set here is higher than in the other places.
I have a bad habit of leaving this on too long in here
And the kitchen, turn on the lights and turn off the lights when my presence is’t detected anymore.
Bad habit of leaving the light on because I think I will be back. Or when hands are full with snacks