Hi Everyone! I’m new to Hubitat and have been migrating stuff slowly from SmartThings over to HE. I’ve recently paired a Yale Z-Wave Door lock. Unlike ST, I’ve had to move the hub over to the device I want to pair. So, I brought it down near the lock, re-paired the device, and got it connected. Issued some codes, it could open/close. All good. Next day I moved my hub back to its original location. Now I’m trying to get the lock to work, and it’s not locking/unlocking. Since I moved the hub, it did see 1 action where I locked it, but now nothing. I’ve swapped batteries, my codes work. Just no communication back to the hub. I guess it can’t reach the hub? But what’s funny is, there’s a Z-Wave Plus switch right next to it. So, if it can’t get to the hub directly (it’s actually about 15 feet away but through some external walls) it should be using the Z-Wave switch as a mesh. I’ve tried to do the repair on my whole Z-Wave network, but I still have several devices that simply say ‘not responding’ and still work, but this one just says failed. What should I do next? I’ve tried resetting the lock, but it still doesn’t work. Maybe I need to re-pair it entirely. Has anyone else had this issue with Yale locks? Any tips would be greatly appreciated!