Fp300 struggling to understand it uses

Sensor, Product-Review

andrewcsbartlett November 25, 2025, 11:25pm 8

MakerMing:

most of the problems of inaccurate detection can be solved by adjusting the installation position

It would be great if that was true. FP300 thread mode and M100 don’t work.

FP300, Thread, Aqara App Stuck with Presence On for 12 hours so far Everything Matter

Just installed my first FP300 in the Aqara App in Thread mode and it is stuck in ‘presence’. The settings are default and firmware latest. I tried a factory reset to no avail. The user manual helpfully suggests, ‘6.After installation, the device requires time to fully learn the spatial profile of the new environment. In cases of significant environmental interference, occasional false alerts may occur during initial use. Allow the device to continue autonomous learning in an unoccupied space…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled