Hello, as we found out together with @gtxteo , I recommend setting the W100 polling time to 10 minutes, this setting will prevent a failure (disconnection from E1) in the connection between E1->W100.
Hello @AqaraOfficial @gafich10 @Raman.V @DEChrisE
I am experiencing an issue with the long-term stability of the association between the Aqara Radiator Thermostat E1 and the Aqara Temperature Sensor W100.
My Setup:
Hub: Aqara Hub M3
TRV: Radiator Thermostat E1 (Firmware checked and updated)
Sensor: Temperature Sensor W100 (Set in Zigbee mode, Firmware checked and updated)
Protocol: All devices connected via Zigbee to the M3 Hub.
The Problem:
I have successfully configured the E1 valve to…
I think many users are confused by the settings in the W100 sensor. I want to make a short description of this setting.
To find this setting, you need to select it in the W100 splash screen.
[IMG_20250729_184830]
[IMG_20250729_184848]
We will leave the settings for later, after the explanation this question will disappear.
After selecting manual settings, the following selection window appears.
The “Samnling period” setting is responsible for the speed of data update on the physical, I em…
3 Likes